Left Fuel Rail (G1557477): Removal
WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure that tools and equipment are clean and free of foreign material and lubricant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
- Refer to: FUEL SYSTEM PRESSURE RELEASE - V6 S/C 3.0L PETROL/V8 S/C 5.0L PETROL
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - V8 S/C 5.0L PETROL
- Refer to: SECONDARY BULKHEAD LEFT PANEL
- Refer to: FUEL INJECTION COMPONENT CLEANING (G1202495)
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION:
- Be prepared to collect escaping fluids.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
Special Tool(s): 303-1450
-
CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
-
CAUTION:
- Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
- Make sure that the special tool is held square to the fuel injector during removal.
- Make sure that all open ports are covered to prevent any foreign material ingress.
NOTE: RH illustration shown, LH is similar.Special Tool(s): 310-197
Remove and discard the fuel injector clamp.
-
CAUTION:
- Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
- Do not cut the Teflon seal to deep as damage could occur to the fuel injector.
- Pinch the Teflon seal to allow the tool to cut the Teflon seal without damaging the fuel injector.
Remove and discard the fuel injector seal.
-
CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
Remove and discard the fuel injector O-ring seals.