High Pressure Fuel Pump 1 - RWD (G1280008): Removal
WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may ignite. Failure to follow these instructions may result in personal injury.
CAUTION:
Make sure that tools and equipment are clean, free of foreign material and lubricant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
- Refer to: FUEL SYSTEM PRESSURE RELEASE - V6 S/C 3.0L PETROL/V8 S/C 5.0L PETROL
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - V6 S/C 3.0L PETROL
- Refer to: ENGINE OIL VACUUM DRAINING AND FILLING (G1779628)
- Refer to: FUEL INJECTION COMPONENT CLEANING (G1202495)
-
CAUTION: Be prepared to collect escaping fluids.
- Refer to: RIGHT AIR CLEANER (G1549757)
-
CAUTION:
- Be prepared to collect escaping fluids.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
CAUTION:
- Be prepared to collect escaping fluids.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: RIGHT ENGINE MOUNT - RWD (G1557019)
- Refer to: GENERATOR
-
NOTE: Engine shown removed for clarity.
-
NOTE: Engine shown removed for clarity.
-
NOTE: Engine shown removed for clarity.
-
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
CAUTION:
- Remove and discard the high-pressure fuel supply lines.
- Be prepared to collect escaping fluids.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE: Engine shown removed for clarity. -
CAUTION: Be prepared to collect escaping fluids.
Loosen the Torx screws a turn each at a time.
-
CAUTION: Be prepared to collect escaping fluids.