Right Exhaust Manifold (G1557022): Removal

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some illustrations may show the engine removed for clarity.

The following step(s) applies to:

All vehicles

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: EXHAUST SYSTEM - RWD
Refer to: EXHAUST SYSTEM - AWD

The following step(s) applies to:

Right-hand drive vehicles

Refer to: STEERING GEAR - RWD
Refer to: STEERING GEAR - AWD

The following step(s) applies to:

All vehicles

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tool to remove the exhaust manifold bolts.

Install the Special Tool(s): JLR-303-1652
CAUTION:
- Discard the bolts.
- LH illustration shown, RH is similar.
NOTE:
- Discard the gasket.
- Make sure that the position of the spacers is noted before removal of the manifold.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the Special Tool(s): JLR-303-1652
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC