Oil Pan - RWD (G1779629): Installation

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: A new O-ring seal is to be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Oil level gauge O-ring seal Quantity: 1 .

Torque : 12 Nm
CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Use only a plastic scraper when removing the sealing material.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Apply RTV sealant (Loctite 5901G or Loctite 5900) in a 2-3 mm diameter to the areas shown, and tighten the bolts within 7 minutes.
NOTE: Tighten the bolts in the indicated sequence.

Fig 1: Oil Pan Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 12 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Refer to: ENGINE OIL VACUUM DRAINING AND FILLING (G1779628)
Connect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT