LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XJR575 >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Engine - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine - V6 S/C 3.0L Petrol (G2292098) >> Removal And Installation >> Oil Cooler (G1557024) >> Removal

Oil Cooler (G1557024): Removal

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  1. Disconnect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING (G1269230)
  4. Refer to: SUPERCHARGER (G1549762)
  5. G11309801Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  6. CAUTION:
    • Be prepared to collect escaping oil.
    • Be prepared to collect escaping coolant.
    G11309802Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  7. CAUTION:
    • Make sure that these components are installed to the noted removal position.
    • Be prepared to collect escaping coolant.
    • Be prepared to collect escaping oil.
    NOTE: Discard the gasket.
    G11309803Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  8. CAUTION: Make sure that these components are installed to the noted removal position.
    NOTE: Discard O-ring seals.
    G11309804Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
scientia non olet · About LEMON Manuals