Left Exhaust Manifold (G1557021): Removal
WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
The following step(s) applies to:
All vehicles
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: EXHAUST SYSTEM - RWD
Refer to: EXHAUST SYSTEM - AWD
The following step(s) applies to:
Left-hand drive vehicles
- Refer to: STEERING GEAR - RWD
Refer to: STEERING GEAR - AWD
The following step(s) applies to:
All vehicles
- Refer to: POWER STEERING PUMP - V6 S/C 3.0L PETROL (G1557178)
-
NOTE: Remove and discard the O-ring seal.
Use the special tool to remove the exhaust manifold bolts.
Install the Special Tool(s): JLR-303-1652
-
CAUTION: Discard the bolts.NOTE:
- Discard the gasket.
- Make sure that the position of the spacers is noted before removal of the manifold.
Remove the Special Tool(s): JLR-303-1652
-
NOTE: Do not disassemble further if the component is removed for access only.