Engine Oil Vacuum Draining And Filling (G1779628): Filling

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Install new O-ring seals.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Lubricate the oil filter element O-ring seal with clean engine oil.

Renew Part: Oil filter O-ring seal(s) Quantity: 1 .

Renew Part: Oil filter Quantity: 1 .
CAUTION: Tighten the component finger tight first.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Torque : 25 Nm
CAUTION: Make sure that the vehicle is left for 5 minutes from filling with oil and that the engine oil level is reading at least minimum (by following Steps 7-14), before starting the engine.
- Fill the engine with oil:
  Refer to: Capacities
- Clean any residual engine oil from the oil filler cap area.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Make sure that the vehicle has been left for 5 minutes from filling with oil.

Follow the Steps 7-14 before starting the engine.
- Start the engine and allow to run for 10 minutes, stop the engine.
- Check for leaks.
CAUTION:
- Make sure that the selector lever and the gearshift mechanism are in the park (P) position.
- Make sure that the hood is open.
- Turn the ignition on.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand directional button to access the instrument cluster menu.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand OK button.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand directional button to access the Oil Level Display.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand OK button and follow the instructions.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the cruise control cancel button twice within 2 seconds.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- The message center display will revert to the normal display in the trip computer.
- Press the right-hand OK button and follow the instructions.
- Check that the oil level display shows an oil level reading.
- Only after having started and run the engine for 10 minutes (as indicated in Step 6), switch off the engine, then stabilizing for 10 minutes, take a reading from the oil level display and, if necessary top up with engine oil.
NOTE: If instructed to follow Steps 7-14 in a previous step, return to Step 6 and continue the procedure.

Turn the ignition off.
Allow 10 minutes for the engine oil level to stabilize if there has been additional oil top up.
NOTE: The following steps are to update the average oil level value.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Turn the ignition on.
- Press and hold the cruise control cancel button for more than 2 seconds.
- The message center display will revert to the normal display in the trip computer.
Turn the ignition off.
Turn the ignition on.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand directional button to access the instrument cluster menu.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand OK button.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand directional button to access the Oil Level Display.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Press the right-hand OK button and follow the instructions.
- Make sure that the average oil level value has now been updated.
Refer to: ENGINE COVER - V8 S/C 5.0L PETROL