Engine Oil Vacuum Draining And Filling (G1779628): Draining

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The spilling of hot engine oil is unavoidable during this procedure, care must be taken to prevent scalding.

CAUTION: Correct installation of the oil filler cap can be obtained by tightening the cap until hard stop.

NOTE:

Make sure that the vehicle is parked on level ground.
Clean the components general area prior to dismantling.
Some variation in the illustrations may occur, but the essential information is always correct.
Engine oil vacuum draining and filling is the recommended procedure for engine oil change during a scheduled service. Scheduled service labour times are calculated using this method.

- Start the engine and allow to run for 10 minutes, stop the engine.
CAUTION: Allow 10 minutes from turning the engine off before starting oil extraction.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Refer to: ENGINE COVER - V8 S/C 5.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Loosen the element cover 4 complete turns to allow engine oil to drain from the filter cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using the oil vacuum pump drain the oil out through the oil extraction tube.
Special Tool(s): JLR-303-1644
- Remove the oil vacuum pump.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: Discard the O-ring seals.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC