LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XJR575 >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - V8 S/C 5.0L Petrol -- XJ/X351 >> Engine Cooling - V8 S/C 5.0L Petrol (G1269229) >> Removal And Installation >> Rear Coolant Manifold (G2368814) >> Installation

Rear Coolant Manifold (G2368814): Installation

  1. NOTE: This step is only required if new components are not installed.

    Install 2 new O-ring seals to the rear coolant manifold.

    Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2  .

    • Install the rear coolant manifold.
    • Install and tighten the 4 bolts.

      Torque  : 9 Nm 

    • Connect the electrical connector.
    • Install the wiring harness clip.
    • Connect the rear coolant manifold left hose.
    • Install the coolant hose clip.
    • Install the rear coolant manifold right hose.
    • Connect the 2 coolant hose connectors.
  6. Install the secondary bulkhead left panel.

    Refer to: SECONDARY BULKHEAD LEFT PANEL

  7. Install the secondary bulkhead right panel.

    Refer to: SECONDARY BULKHEAD RIGHT PANEL

  8. Vacuum fill the coolant system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1816935) 

scientia non olet · About LEMON Manuals