Throttle Body (G1269164): Removal

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1816935)
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE:
- This step should only be carried out on vehicles pre 2015.
- Remove and discard the seals.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Engine coolant outlet seal Quantity: 1 .

Torque : 10 Nm
NOTE:
- This step should only be carried out on vehicles from 2015 onwards.
- Remove and discard the seal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Engine coolant outlet seal Quantity: 1 .

Torque : 10 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 10 Nm
CAUTION:
- Take extra care when removing the throttle body, failure to follow this instruction may result in damage to the manifold absolute pressure and temperature (MAPT) sensor.
- Do not attempt to clean the throttle body bore, build up of deposits reduces air leakage past the throttle plate at the fully closed position.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the gasket.
- Install a new gasket.
  Renew Part: Throttle body gasket Quantity: 1 .