LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XJR575 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging And Controls - V8 S/C 5.0L Petrol -- XJ/X351 >> Fuel Charging And Controls - V8 S/C 5.0L Petrol (G1281373) >> Removal And Installation >> Right Fuel Rail (G1280006) >> Installation

Right Fuel Rail (G1280006): Installation

  1. CAUTION: Lubricate only the union threads with clean engine oil.
    NOTE:
    • Engine shown removed for clarity.
    • Install the bolts and unions finger tight before final tightening.
    • Remove and discard the blanking caps.
    G11285490Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Renew Part: Fuel rail supply pipe(s) Quantity: 1  .

  2. G11288087Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 48 Nm 

  3. G11285410Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the special tool.

  4. G11288085Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 48 Nm 

  5. NOTE: Some components shown removed for clarity.
    G11288093Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque 

    • Unions (1): 21 Nm 
    • M6 (2): 11 Nm 
    • M8 (3): 25 Nm 
  6. G11288044Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install new fuel injector O-ring seals.

    Renew Part: Fuel Injector replacement kits Quantity: 1  .

  7. G11288046Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install new Teflon seals on the lower tips of the injectors.

    Special Tool(s): 310-198 

  8. G11288047Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Special Tool(s): 310-199 

  9. G11288042Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install a new fuel injector clamp.

  10. CAUTION: If a new cylinder head has been installed then the special tool 310-200-02 without the thread must be used to install the fuel rail.
    G11288049Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Special Tool(s): 310-200-01  , 310-200-02 

  11. CAUTION:
    • Make sure that the area around the open fuel injector ports are clean and free of foreign material and lubricant prior to installing the fuel injector.
    • When Installing the fuel injector(s), make sure that the Teflon seal is clean and free of foreign material and lubricant.
    G11288050Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  12. NOTE: This step is only required if a new fuel rail is installed.

    Refer to: FUEL RAIL PRESSURE SENSOR (G1574132)

  13. CAUTION:
    • If new fuel injectors are installed, a new injector clamp must be installed
    • Make sure that the fuel injector is aligned and installed into the fuel rail correctly, as noted in the removal step.
    • Tighten the fuel rail retaining bolts a turn at a time until the correct torque is achieved.
    NOTE: Lubricate the fuel injector O-ring seals with clean engine oil.
    G11288051Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 20 Nm 

  14. NOTE: LH shown RH similar.
    G11288052Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Special Tool(s): 310-200-01  , 310-200-02 

  15. NOTE: LH shown RH similar.
    G11288053Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 20 Nm 

  16. NOTE:
    • LH shown RH similar.
    • Tighten in the sequence indicated.
    G11288054Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque 

    • Bolt 2: 30 Nm 
    • Bolt 3: 30 Nm 
    • Bolt 1: 30 Nm 
    • Bolt 4: 30 Nm 
  17. G11288076Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  18. NOTE: LH shown RH similar.
    G11288038Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 7 Nm 

  19. NOTE: LH shown RH similar.
    G11288057Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  20. NOTE: Remove and discard the blanking caps.
    G13882586Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque 

    • Unions: 21 Nm 
    • Nut: 6 Nm 
  21. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  22. NOTE: Some components shown removed for clarity.
    G11288108Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 21 Nm 

  23. NOTE: Engine shown removed for clarity.
    G11288084Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Torque 
      • M10: 29 Nm 
      • M6: 11 Nm 
  24. NOTE: Engine shown removed for clarity.
    G11285155Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  25. G11284999Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 25 Nm 

  26. Refer to: GENERATOR - V8 S/C 5.0L PETROL
  27. Refer to: ENGINE UNDERSHIELD
  28. Lower the vehicle.
  29. G11285152Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  30. NOTE:
    • Lubricate the union threads with clean engine oil.
    • Do not tighten at this stage.
    • Remove and discard the blanking caps.
    G11286155Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  31. G11286155Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque 

    • Unions: 21 Nm 
    • Bolts: 8 Nm 
  32. G11286769Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 21 Nm 

  33. G11288237Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  34. G11288197Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  35. G11288195Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  36. G11288194Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  37. Refer to: RIGHT AIR CLEANER (G1271880)
  38. Refer to: SECONDARY BULKHEAD RIGHT PANEL
  39. Refer to: ENGINE COVER - V8 S/C 5.0L PETROL
  40. Refer to: STARTUP BATTERY DISCONNECT AND CONNECT