High Pressure Fuel Pump 2: Installation
-
NOTE: Lubricate the fuel rail high-pressure fuel pump bucket with clean engine oil.
-
CAUTION: Tighten the Torx screws a turn at a time until the correct torque is achieved.NOTE: Lubricate the fuel rail high-pressure fuel pump O-ring seal with clean engine oil.
Install the high-pressure fuel pump.
Torque : 12 Nm
Loosen the Torx screws half a turn each.
-
CAUTION:
- Install new high-pressure fuel supply lines.
- Lubricate the high-pressure fuel supply line unions with clean engine oil.
NOTE: Engine shown removed for clarity.Install the high-pressure fuel supply lines, tighten the bolts and unions finger tight at stage.
-
CAUTION: Care must be taken when positioning the fuel rail high-pressure fuel pump cover to one side.
Tighten the Torx screws.
Torque : 12 Nm
- Lower the vehicle.
-
CAUTION: Lubricate only the union threads with clean engine oil.NOTE: Engine shown removed for clarity.
Torque
- Unions (1): 21 Nm
- M6 (2): 11 Nm
- M8 (3): 25 Nm
- M5 nut (4): 6 Nm
Torque
- Unions: 21 Nm
- Bolt: 12 Nm
-
NOTE: Install the bolt and unions finger tight before final tightening.
Torque
- Unions: 21 Nm
- M6: 11 Nm
-
NOTE: Engine shown removed for clarity.
Torque
- M10: 29 Nm
- M6: 11 Nm
Torque : 25 Nm
- Refer to: GENERATOR - V8 S/C 5.0L PETROL
- Refer to: RIGHT ENGINE MOUNT (G1271918)
-
NOTE:
- Lubricate the union threads with clean engine oil.
- Do not tighten at this stage.
Torque
- Unions: 21 Nm
- Bolts: 8 Nm
- Refer to: RIGHT AIR CLEANER (G1271880)
- Refer to: ENGINE COVER - V8 S/C 5.0L PETROL
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE OIL VACUUM DRAINING AND FILLING (G1280232)