Suspension Air Supply Unit (G2413635): Removal

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 electrical connector.
- Release the wiring harness clip.
WARNING: A small amount of air pressure will be left in the air suspension system.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the air line connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 nuts.
- Remove the suspension air supply unit from the vehicle.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use suitable tape to cover the air line and electrical connector openings.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 mounting brackets.
CAUTION: Do not reuse the air line connector. Always install a new air line connector every time it is released.

Remove and discard the air line connector.

Refer to: AIR LINE CONNECTOR - SPORTBRAKE