Ignition Coil-On-Plug : Installation

WARNING: This page is about a different variant/trim than selected.

WARNING: Make sure that the ignition coil rubber boot is pushed down fully over the spark plug insulator ceramic. Double check by installing the ignition coil as usual and then pushing on the ignition coil head gently for a second time to make sure that the ignition coil rubber boot has seated correctly over the spark plug insulator.

Install the 4 ignition coils.
- Install the 4 retaining bolts.
  Torque : 8 Nm
- Install the 4 electrical connectors.
Connect the fuel rail electrical connector.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL