Thermostat (G1796011): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING
NOTE: This step only applies to vehicles equipped with High Pressure (HP) Exhaust Gas Recirculation (EGR) system.

Refer to: HIGH PRESSURE EXHAUST GAS RECIRCULATION COOLER
NOTE:
- If equipped.
- Remove and discard the gasket.
- Remove and discard the O-ring seal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: EGR inlet pipe to EGR valve gasket Quantity: 1.

Renew Part: EGR pipe to intake manifold O-ring seal Quantity: 1.

Torque

EGR pipe to EGR valve bolts: 12 Nm

EGR pipe to Intake manifold bolts: 7 Nm
CAUTION: Be prepared to collect escaping coolant.

NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Be prepared to collect escaping coolant.

NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque: 12 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: Remove and discard the gasket.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Thermostat to cylinder block gasket Quantity: 1.