General Specification
WARNING: This page is about a different variant/trim than selected.
| ITEM | SPECIFICATION |
|---|---|
| Type | 2.0 litre, inline 4, turbocharged and intercooled petrol engine, tandem overhead camshaft, 4 valves per cylinder |
| Cylinder arrangement | Inline 4 |
| Cylinder numbering | No. 1 from the accessory drive end |
| Bore - nominal | 83.0 mm (3.270 in) |
| Stroke | 92.29 mm (3.633 in) |
| Capacity | 1997 cm3 (121.9 in3 ) |
| Firing order | 1 - 3 - 4 - 2 |
| Spark plug gap | 0.7-0.8 mm |
| Direction of rotation | Clockwise viewed at FEAD |
| Compression ratio - Low and Mid spec | 10.5:1 |
| Compression ratio - High spec | 9.5:1 |
| Cylinder head maximum permitted warp (flatness specification) | 0.2 mm (0.008 in) |
| Cylinder block maximum permitted warp (flatness specification) | 0.15 mm (0.006 in) |
| Maximum power/torque - Low spec | |
| Maximum power | 147 kW (200 PS) @ 5500rpm |
| Maximum Torque | 320 Nm (236 lb/ft) @ 1300 - 4000rpm |
| Maximum power/torque - Mid spec | |
| Maximum power | 184 kW (250 PS) @ 5500rpm |
| Maximum Torque | 365 Nm (269 lb/ft) @ 1200 - 4500rpm |
| Maximum power/torque - High spec | |
| Maximum power | 221 kW (300 PS) @ 5500rpm |
| Maximum Torque | 400 Nm (295 lb/ft) @ 1500 - 4500rpm |
| Crankshaft end play: | |
| Minimum | 0.15 mm |
| Maximum | 0.35 mm |
| Main bearing clearance: | |
| Minimum | 0.030 mm |
| Maximum | 0.054 mm |