Valve Cover (G2029687): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if previously removed.

Fig 1: Inlet Camshaft Bearing Cap Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the inlet camshaft.
- Install the camshaft bearing caps into the previously noted position. Lubricate the camshaft and the camshaft bearing caps with a small quantity of clean engine oil.
- Tighten the 10 camshaft bearing cap bolts following the tightening sequence as illustrated.
  Torque: 11 Nm
NOTE: This step is only required if previously removed.

Fig 2: Exhaust Camshaft Bearing Cap Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the exhaust camshaft.
- Install the camshaft bearing caps into the previously noted position. Lubricate the camshaft and the camshaft bearing caps with a small quantity of clean engine oil.
- Tighten the 10 camshaft bearing cap bolts following the tightening sequence as illustrated.
  Torque: 11 Nm
NOTE: This step is only required if previously removed.

Install the oil filler pipe and tighten the retaining bolt to the correct torque. Make sure that a new O-ring seal is installed.

Renew Part: Oil fill pipe O-ring seal Quantity: 1.

Torque: 12 Nm
NOTE: This step is only required if previously removed.

Install the Camshaft Position (CMP) sensors.

Torque: 8 Nm
Install a new valve cover gasket.
Renew Part: Camshaft cover gasket Quantity: 1.
Fig 3: Valve Cover Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the valve cover.
- Install and tighten the bolts in the sequence illustrated to the joining torque figure.
  Torque: 10 Nm
- Tighten the bolts in the sequence illustrated to the final torque figure.
  Torque: 28 Nm
Install the coolant bypass hose into the correct position. Tighten the 2 retaining studs to the correct torque.
Torque: 10 Nm
Install the 2 engine cover support mounts and tighten to the correct torque.
Torque: 6 Nm
- Install the wiring harness into the correct position.
- Install the 2 retaining bolts and tighten to the correct torque.
  Torque: 6 Nm
- Connect the 8 electrical connectors.
Install the accessory drive belt.
Refer to: ACCESSORY DRIVE BELT .
Install the high pressure fuel pump.
Refer to: HIGH PRESSURE FUEL PUMP (G2043272)
Install the evaporative emission canister purge valve.
Refer to: EVAPORATIVE EMISSION CANISTER (G1914787)
Install the oil separator and crankcase vent assembly.
Refer to: VALVE COVER VENT OIL SEPARATOR .
Install the fuel injectors.
Refer to: FUEL INJECTORS (G1998238)
Install the Continuous Variable Valve Lift (CVVL) assembly.
Refer to: CONTINUOUS VARIABLE VALVE LIFT .
Install the upper timing chain.
Refer to: UPPER TIMING CHAIN .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .