LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - INGENIUM I4 2.0L Petrol -- XF/(X260)) >> Engine - INGENIUM I4 2.0L Petrol (G2289429) >> Removal And Installation >> Oil Pump Chain (G2046496) >> Removal

Oil Pump Chain (G2046496): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING .

    General Equipment: 2 post lift 

  2. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

  3. Remove the oil pan.

    Refer to: OIL PAN .

  4. G13894508Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Using the special tool to hold the oil pump sprocket, remove and discard the bolt.

      Special Tool(s): 205-053 

    • Remove the oil pump gear.
    • Remove the oil pump chain.
scientia non olet · About LEMON Manuals