FLEXPLATE (G1997940): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Under no circumstances should the drive plate retaining bolts be inserted into the crankshaft with the drive plate removed. Failure to follow this instruction will result in damage to the engine.

NOTE: Do not insert the bottoming tap more than the depth of the threaded holes (16 mm). Apply tape to the bottoming tap 16 mm from the end as a visual guide.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using a suitable bottoming tap, clean out the threads.
- Using suitable brake cleaner, remove any foreign material from the threads.
NOTE:
- The drive plate will only locate in one position.
- Install new bolts.
Fig 1: Drive Plate Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the drive plate.
- Install the 8 retaining bolts from the drive plate kit.
  Renew Part: Flexplate bolts Quantity: 1.
  
  Torque
  
  Stage 1: 30 Nm
  
  Stage 2: 120°
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the crankshaft pulley special tool.

Special Tool(s): JLR-303-1630
Install the transmission assembly.
Refer to: TRANSMISSION - INGENIUM I4 2.0L PETROL .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .