Continuous Variable Valve Lift Oil Temperature Sensor (G2148902): Installation
WARNING: This page is about a different variant/trim than selected.
-
CAUTION:
- Do not touch the tip of the Continuous Variable Valve Lift (CVVL) oil temperature sensor.
- Lubricate the threaded section of the Continuous Variable Valve Lift (CVVL) oil temperature sensor with clean engine oil.
- Install and tighten the CVVL oil temperature sensor.
Torque: 18 Nm
- Connect the electrical connector to the CVVL oil temperature sensor.
-
- Install the breather pipe.
- Connect the breather pipe.
- Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .