Description And Operation: Engine: Overview

The Ingenium I4 2.0L Petrol is an inline four cylinder, turbocharged engine that employs advanced modular design principles.

The engine features a split cooling system. The system contains a Powertrain Control Module (PCM) controlled electric thermostat and a fully variable coolant pump. The variable coolant pump enables engine coolant to remain static in the engine to maximize heat transfer during warm up. When engine coolant flow is required for engine cooling, the minimum flow is provided by the variable coolant pump.

The split cooling thermostat housing limits coolant flow in the cylinder block while allowing engine coolant to circulate through cross flow channels in the cylinder head. Parasitic losses are also optimized when the variable coolant pump is delivering reduced flow.

An electronically controlled variable flow oil pump with integral vacuum pump matches its flow rate according to engine speed, load and temperature. Oil flow to the piston cooling oil jets is solenoid controlled and operates only when needed.

The two camshafts incorporate Variable Camshaft Timing (VCT) system. VCT system allows the timing of the intake and exhaust valves to be adjusted independently of each other. The VCT system is controlled by the PCM using information from Camshaft Position (CMP) sensors.

Beside the VCT there is a continuously variable valve lift system that can adjust the intake valve lift timing. The continuously variable valve lift system allows the engine to always operate at optimal efficiency. The continuously variable valve lift system reduces fuel consumption and increases power and torque in the lower speed range. The continuously variable valve lift system is controlled by the PCM.

The engine uses a Bosch High Pressure (HP) Direct Injection (DI) fuel system. The fuel pressure is provided by a HP fuel pump which is driven from the exhaust camshaft. The HP fuel pump supplies the fuel rail, and then the fuel rail supplies the four fuel injectors with fuel at a controlled pressure.

There are many dynamic and static seals on the engine. Unless otherwise specified all seals and gaskets shall be considered single use and if they are removed shall be replaced.

Various engine systems are located on the engine assembly and driven directly and indirectly by the engine operation. Refer to relevant article for the further information:

• Engine cooling For additional information, Refer to: ENGINE COOLING .
• Fuel system For additional information, Refer to: FUEL TANK AND LINES - INGENIUM I4 2.0L PETROL
• Air intake system For additional information, refer to: INTAKE AIR DISTRIBUTION AND FILTERING .
• Engine emission control For additional information, refer to: ENGINE EMISSION CONTROL .
• Accessory drive For additional information, refer to: ACCESSORY DRIVE .
• Starting system For additional information, refer to: STARTING SYSTEM .
• Turbocharger For additional information, Refer to: TURBOCHARGER (G2058418)
• Electronic engine controls For additional information, Refer to: ELECTRONIC ENGINE CONTROLS .