Fuel Rail (G2032604): Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Extreme cleanliness must be exercised when handling these components. Make sure that all tools and the surrounding area is clean before commencing work.
- When the fuel rail is removed all the fuel injector seals must be replaced at the same time.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustration showing certain components removed to provide extra clarity.
- Before working on the fuel system make sure to study the fuel system health and safety article of this information.
Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
- Release the fuel pressure.
Refer to: FUEL SYSTEM PRESSURE RELEASE
- Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS
- Clean all the fuel tube unions and the surrounding area before working on the fuel system.
- Remove the fuel injectors.
Refer to: FUEL INJECTORS (G1998238)
-
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
Remove the fuel rail pressure sensor.