Post Catalyst Heated Oxygen Sensor (G2271369): Installation

1. • Using the special tool, install the post catalyst heated oxygen sensor.

     Special Tool(s): JLR-303-1666 

     Torque  : 48 Nm 

   • If the sensor is not being replaced with a new component. Make sure that a suitable anti seize grease is applied to the sensor thread.
2. Install the clips.
3. Connect the post catalyst heated oxygen sensor electrical connector.
4. Install the air deflector.

   Refer to: ENGINE UNDERSHIELD

5. Install the engine cover.

   Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL

6. Connect the startup battery ground cable.

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT