Exhaust Camshaft Position Sensor (G2020273): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Apply a thin film of Castrol Classic GP-50 to the camshaft position sensor bore.
- Install a new O-ring seal to the exhaust camshaft position sensor.
  Renew Part: Camshaft position sensor O-ring seal Quantity: 1 .
- Install the exhaust camshaft position sensor.
- Install and tighten the bolt.
Torque : 8 Nm
Connect the electrical connector.
Connect the breather pipe.
Install the engine cover.

Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL