Exhaust System - INGENIUM I4 2.0L Petrol (G2020236): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if previously removed.
- Install the exhaust cross brace.
- Connect the exhaust hanger brackets.
CAUTION: Make sure the exhaust system is supported at all times.
- With assistance from another technician, install the exhaust system.
- Install and tighten the 4 bolts.
  Torque : 25 Nm
CAUTION: Make sure the exhaust system is supported at all times.

With assistance from another technician, support the exhaust system and connect the 4 hanger brackets.
- Install the left and right undershield.
- Install and tighten the 4 nuts.
  Torque : 5 Nm
- Instal and tighten the 10 bolts.
  Torque : 5 Nm
- Install the 18 fasteners.
NOTE: If equipped.
- Install the center undershield.
- Install and tighten the 2 nuts and the 4 bolts.
  Torque : 5 Nm
NOTE: Install a new exhaust clamp.

Install the exhaust into position and secure with a new clamp between the exhaust system and the catalytic converter assembly.

Renew Part: Front exhaust clamp Quantity: 1 . Part Number:

Torque : 56 Nm
Lower the vehicle.