Pre Selective Catalyst Reduction NOX Sensor (G2272231): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Make sure the anti-seize compound does not contact the pre Selective Catalyst Reduction (SCR) NOx sensor tip.
- If accidentally dropped or knocked install a new pre (SCR) NOx sensor.
Using the special tool, install the pre Selective Catalyst Reduction (SCR) NOx sensor.

Special Tool(s): JLR-303-1666

Torque : 48 Nm
Install the pre SCR NOx sensor module.
Install the air deflector.
Refer to: ENGINE UNDERSHIELD
- Install the wiring harness into the 4 clips.
- Connect the electrical connector to the pre SCR NOx sensor module.
Connect the startup battery ground cable.