Post Selective Catalyst Reduction NOX Sensor (G2272232): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Make sure the anti-seize compound does not contact the pre selective catalyst reduction NOx sensor tip.
- If accidentally dropped or knocked install a new post selective catalyst reduction soot sensor.
Using the special tool install and tighten the post Selective Catalyst Reduction (SCR) NOx sensor.

Special Tool(s): JLR-303-1666

Torque : 60 Nm
- Install the post SCR NOx sensor module.
- Connect the electrical connector.
- Connect the electrical connector.
- Install the wiring harness to the 2 clips.
- Install the right side undershield.
- Install and tighten the 6 bolts.
  Torque : 7 Nm
- Install and tighten the 6 nuts.
  Torque : 7 Nm
- Install and tighten the 5 fasteners.
Connect the startup battery ground cable.