LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- XF/(X260)) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1817213) >> Removal And Installation >> Clutch Pedal Position Sensor (G1858363) >> Installation

Clutch Pedal Position Sensor (G1858363): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install and rotate the clutch master cylinder to the pedal assembly.
    • Install and rotate the guide pin.
    • Install the clutch pedal assembly.
    • Install and tighten the 3 nuts.

    Torque  : 24 Nm 

  3. Connect the electrical connector to the clutch pedal switch.
  4. Connect the electrical connector to the clutch master cylinder.
  5. CAUTION: An audible click is heard when the retainer is located correctly.
    • Connect the high pressure pipe to the clutch master cylinder.
    • Install the retainer.
  6. Connect the low pressure pipe to the clutch master cylinder.
  7. NOTE: An audible click is heard when the electrical connector is located correctly.

    Install the engine wiring harness to the bracket.

  8. Install the instrument panel lower trim panel.

    Refer to: INSTRUMENT PANEL LOWER TRIM PANEL

  9. Install the cowl panel.

    Refer to: COWL PANEL

scientia non olet · About LEMON Manuals