Compressor Bypass Valve - INGENIUM I4 2.0L Diesel - High Power (G2224797): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Drain the engine cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the charge air cooler intake pipe.
Remove the Low Pressure (LP) Exhaust Gas Recirculation (EGR) cooler.
Refer to: LOW PRESSURE EXHAUST GAS RECIRCULATION COOLER
CAUTION: Be prepared to collect escaping engine coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the turbocharger coolant hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the Compressor Bypass Valve (CBV).
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the turbocharger to CBV seals.