Auxiliary Fuel Pump (G2473719): Installation
WARNING: This page is about a different variant/trim than selected.
-
NOTE: Only do steps 1 - 2, if a new component has been installed.
- Install the auxiliary fuel pump.
- Install the 2 fuel lines.
- Install a new hose clamp.
Renew Part: Hose clamp Quantity: 1 .
-
- Install the auxiliary fuel pump cover.
- Install and tighten the 3 nuts.
Torque : 10 Nm
-
- Install the fuel filter and auxiliary fuel pump assembly.
- Connect the 2 electrical connectors.
- Install the 2 wiring harness clips.
- Install and tighten the 4 bolts.
Torque : 10 Nm
-
- Install the 4 fuel lines.
- Install the 2 fuel line clips.
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Bleed the fuel system.
Refer to: FUEL SYSTEM BLEEDING