Crankshaft Pulley (G181144): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Disconnect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Refer to: ACCESSORY DRIVE BELT
Refer to: CHARGE AIR COOLER
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 12 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 90 Nm
NOTE: Only rotate the crankshaft clockwise.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install special tool JLR-303-1630 to crankshaft damper. Make sure central hub is located correctly.

Special Tool(s): JLR-303-1630
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove four crankshaft damper bolts.

Special Tool(s): JLR-303-1630

Renew Part: Crankshaft pulley bolts Quantity: 4 .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove crankshaft damper.

Special Tool(s): JLR-303-1630
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool remove and discard the front crankshaft seal.

Special Tool(s): JLR-303-1628

Renew Part: Crankshaft front oil seal Quantity: 1 .