Roof Opening Panel

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Operation of the roof opening panel is controlled by the roof opening panel control module, which is integral with the motor. The control module receives inputs from the BCM/GWM, which provides an 'open' or 'close' signal for smart key operation, and an 'enable' signal when the vehicle enters power mode 6.

If the battery is disconnected, or the power supply is interrupted while the roof opening panel is in a partially open position, the motor and control module will need to be calibrated to restore full functionality.

Follow these steps to recalibrate the roof opening panel:

Switch on the ignition (Power Mode 6).
Press the front of the roof opening panel switch, so the roof opening panel is the tilt position, and then release the switch.
Press the front of the switch and hold it for thirty seconds.
After thirty seconds the roof opening panel will begin to move. Keep the front of the switch pressed until the roof opening panel has fully opened and then closed.
As soon as the open/close cycle has completed and the roof opening panel has stopped moving, release the switch.
The roof opening panel can now be operated as normal.