Fuel Rail Supply Pipe (G1867922): Removal
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Avoid flames, sparks or lighted substances.
- Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
CAUTION:
- Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
- Make sure that the area around the component is clean and free of foreign material.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
- Disconnect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL
Remove the noise, vibration and harshness (NVH) material.
-
NOTE: Install the blanking caps.
-
NOTE: Install the blanking caps.
-
NOTE: Remove and discard the gasket and O-ring seal.
-
NOTE: Install the blanking cap.
-
NOTE: Install the blanking caps.
-
CAUTION: Remove and discard the gasket.
-
NOTE: Install the blanking cap.
-
NOTE: Install the blanking cap.
-
CAUTION: Remove and discard the fuel rail high pressure supply pipe.