Brake Pads (G1822059): Removal
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Brake pads must be renewed in axle sets only, otherwise braking efficiency may be impaired.
- If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
NOTE:
Removal steps in this procedure may contain installation details.
- If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM
- Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
-
NOTE: This step is only required if the diagnostic tool is not available.
Set the electronic park brake (EPB) to the maintenance position.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
-
NOTE: This step is only required if the vehicle has no battery power.
Set the electronic park brake (EPB) to the maintenance position.
Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER
- Raise and support the vehicle.
Refer to: LIFTING
- Remove the rear wheel.
Refer to: WHEEL AND TIRE
Remove the spring.
-
NOTE: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
- Remove the 2 dust covers.
- Remove the 2 slide pins.
- Tie the brake caliper aside.
Remove the brake pads.