Brake Disc (G1822057): Removal
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Brake discs must be renewed in axle sets.
NOTE:
Removal steps in this procedure may contain installation details.
- If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM
- Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
-
NOTE: This step is only required if the diagnostic tool is not available.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
-
NOTE: This step is only required if the vehicle has no battery power.
Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: WHEEL AND TIRE
-
CAUTION:
- Make sure that the brake hose does not support the full weight of the brake caliper assembly.
- Discard the bolts.
Tie aside with a suitable tie strap.
Renew Part: Brake caliper carrier bolt(s) Quantity: 2.
Torque
Stage 1: 70Nm
Stage 2: 120°
Torque : 35Nm