LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Steering Column -- XE/(760)) >> Steering Column (G1817735) >> General Procedures >> Steering Column Service Position (G1822871) >> Activation

Steering Column Service Position (G1822871): Activation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure that the steering column lock actuator is not engaged and in the service position. Failure to follow this instruction will make installation of the steering system impossible and may result in damage to the vehicle.
    • Having the steering column lock actuator engaged will restrict the axial displacement of the upper steering column output shaft which is required for installation.
    • If the vehicle doors are locked or when the ignition is switched off and a time delay has elapsed the vehicle will automatically engage the steering column lock actuator blocking the upper steering column rotation. To prevent the steering column lock actuator from being engaged automatically the vehicle battery must be disconnected within 3 minutes of switching the engine off.
    NOTE: The steering column lock actuator is not fitted in all markets however in doubt these instructions must be followed.

    To make sure the steering column lock actuator is not engaged and in the service position follow the instructions below.

  2. Start and run the engine.
  3. Switch the engine off.
  4. Disconnect the vehicle battery within 3 minutes maximum after the engine is switched off.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  5. Verify the steering column lock actuator is not engaged.
scientia non olet · About LEMON Manuals