Roof Blind Calibration
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Roof blind calibration will be lost if the battery is disconnected, or the roof blind motor power supply is interrupted when the roof blind is in motion.
Calibrate the roof blind as follows:
- Start the engine and leave running during the calibration process
- Make sure that the blind is in the fully closed position - press the close switch to achieve this
- Press and hold the close switch again and wait for the cables to double click (it should take approximately 30 seconds), and release the switch
- Within 3 seconds, press and hold the close switch. The roof blind will automatically travel toward the open position and then to the fully closed position. Release the switch when movement is complete