LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Glass, Frames And Mechanisms -- XE/(760)) >> Glass, Frames And Mechanisms (G1823239) >> Description And Operation >> Glass, Frames And Mechanisms (G2823945) >> Operation >> One Touch Mode Reset

One Touch Mode Reset

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

The door window systems require re-calibrating, if the following occur:

When the power supply is restored, to calibrate the door window systems, the following routine must be completed.

When the vehicle is in Power Mode 6 (Ignition ON):

  1. Make sure the startup battery voltage is more than 12V. If the voltage is below 12V, the vehicle need to be in Power Mode 7 (Engine running).
  2. Close the door window by pulling relevant switch until the window is fully closed, then release the switch.
  3. Re-apply the same switch to close the door window and hold for approximately 1 second
  4. Release the switch and repeat step  3 twice.
  5. Repeat the procedure for all remaining door windows.
scientia non olet · About LEMON Manuals