Exhaust Back Pressure Sensor (G2401318): Installation
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
-
- Install the bracket to the Gasoline Particulate Filter (GPF) differential pressure sensor.
- Install and tighten the bolt.
Torque : 7Nm
-
- Install the cover.
- Secure the 3 clips.
-
- Install the GPF differential pressure sensor assembly.
- Install and tighten the bolt.
Torque : 9Nm
- Connect the electrical connector.
-
- Connect the GPF differential pressure sensor high pressure hose.
- Secure the clip.
- Install the engine undershield.
Refer to: ENGINE UNDERSHIELD
- Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL