Active Regeneration

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Under normal driving conditions passive regeneration of the Gasoline Particulate Filter (GPF) is sufficient to not restrict the flow of exhaust gases in the exhaust system. Some driving styles may cause problems with the passive regeneration of the GPF.

Examples of the driving styles that may cause problems with the passive regeneration of the GPF are:

When the vehicles engine is used at low engine speeds or for long periods with the vehicle stationary. Under these conditions the exhaust system temperature may not get sufficiently high to enable passive regeneration of the GPF.
Driving the vehicle at high loads (for example towing at high speeds) for long periods. Insufficient oxygen in the exhaust gases to enable passive regeneration of the GPF.

In these conditions the driver may be shown a GPF warning indicator and messages in the Instrument Cluster (IC) message center. The driver should follow the messages in the IC message center to enable the active regeneration of the GPF.

The Powertrain Control Module (PCM) controls the active regeneration of the GPF. The PCM increases the amount of oxygen in the exhaust gas by increasing the air/fuel ratio. The PCM maintains the temperature in the exhaust system for the regeneration of the GPF to occur. The active regeneration of the GPF can take up to 20 minutes to reduce the GPF soot load to low.

For additional information, Refer to: GASOLINE PARTICULATE FILTER