LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (MULTIFUNCTION Electronic Modules -- XE/(760)) >> MULTIFUNCTION Electronic Modules (G1822851) >> Removal And Installation >> Remote Function Actuator (G2354485) >> Installation

Remote Function Actuator (G2354485): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If equipped.
    • Install the Remote Function Actuator (RFA).
    • Install and tighten the 2 nuts.

      Torque  : 7Nm 

    • Connect the 3 electrical connectors.
  2. NOTE: If equipped.
    • Install the RFA.
    • Install and tighten the 2 nuts.

      Torque  : 7Nm 

    • Connect the 2 electrical connectors.
  3. Install the wiring harness
  4. Install the right rear seat bolster.

    Refer to: REAR SEAT BOLSTER

  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  6. If a new component has been installed, use the Jaguar Land Rover (JLR) approved diagnostic equipment to configure.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals