LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (MULTIFUNCTION Electronic Modules -- XE/(760)) >> MULTIFUNCTION Electronic Modules (G1822851) >> Removal And Installation >> Passenger Door Module (G2251428) >> Installation

Passenger Door Module (G2251428): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the Passenger Door Module (PDM).
    • Install and tighten the 3 screws.

      Torque  : 2Nm 

    • Connect the 2 electrical connectors.
  2. Install the front door trim panel.

    Refer to: FRONT DOOR TRIM PANEL

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  4. If a new component has been installed, configure using the Jaguar Land Rover (JLR) approved diagnostic equipment.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals