Anti-Lock Brake System Control Module - Project 8 (G2249550): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the components are installed in correct orientation.
- Install the Anti-Lock Brake System Control Module (ABS) to the mounting bracket.
- Install and tighten the bolt.
Torque : 23Nm
- Move the wiring harness into the correct position.
- Install and tighten the bolt.
Torque : 10Nm
Connect the electrical connector.
Install and tighten the 6 brake pipe unions.
Torque : 17Nm
Install the 3 clips.
Install the secondary bulkhead right outer panel.
Refer to: SECONDARY BULKHEAD RIGHT OUTER PANEL - PROJECT 8
Install the front right wheel arch liner.
Refer to: FRONT WHEEL ARCH LINER - PROJECT 8
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Bleed the brake system.
Refer to: BRAKE SYSTEM BLEEDING
If a new component has been installed, configure using Jaguar Land Rover (JLR) approved diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment