Anti-Lock Brake System Control Module
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The Anti-lock Brake System (ABS) control module and the Hydraulic Control Unit (HCU) comprise a single unit and must not be separated.
| ITEM | DESCRIPTION |
|---|---|
| 1 | Anti-lock Brake System (ABS) control module |
| 2 | Rear right brake outlet port |
| 3 | Front left brake outlet port |
| 4 | Front right brake outlet port |
| 5 | Rear left brake outlet port |
| 6 | Primary circuit inlet port |
| 7 | Secondary circuit inlet port |
| 8 | Hydraulic Control Unit (HCU) |
| 9 | Electrical connector |
The Anti-lock Brake System (ABS) control module is secured to a mounting bracket. This mounting bracket is located between the front suspension tower and the secondary bulkhead on the opposite side of the driver. The ABS control module is mounted on the rear face of the Hydraulic Control Unit (HCU). The ABS control module uses the HCU to control all of the braking and stability functions by modulating hydraulic pressure to the individual brakes.
If an ABS control module fault is detected, the 'ABS FAULT' message appears in the Instrument Cluster (IC) message center. At the same time the amber warning indicator comes on.