Powertrain Mount Settling (G2788511): Activation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the right engine mount nut.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the left engine mount nut.
Remove the fender splash shield.
Refer to: FRONT WHEEL ARCH LINER (G2401291)
WARNING: Observe due care when working near a hot exhaust system.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the Diesel Particulate Filter (DPF) fasteners.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the transmission mount fasteners.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the transmission mount fasteners.
WARNING: Observe due care when working near a hot exhaust system.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the exhaust clamp.
Lower the ramp fully.
1. To align the exhaust, follow the steps below.
2. Start and stop the engine 4 times.
3. Start the engine.
4. Raise the engine Revolutions Per Minute (RPM) to between 3000 RPM and 4000 RPM - Repeat this 5 times.
5. Stop the engine.
6. Start and stop the engine 5 times.
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the right engine mount nut.

Torque : 60Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the left engine mount nut.

Torque : 60Nm
Raise the vehicle on the ramp.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the transmission mount fasteners.

Torque : 60Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the transmission mount fasteners.

Torque : 60Nm
WARNING: Observe due care when working near a hot exhaust system.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the DPF fasteners.

Torque : 25Nm
WARNING: Observe due care when working near a hot exhaust system.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the exhaust clamp.

Torque : 55Nm
Install the engine undershield.
Refer to: FRONT WHEEL ARCH LINER (G2401291)