LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (Engine System - General Information -- XE/(760)) >> Engine System - General Information >> Diagnosis And Testing >> Engine - V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol (G1883203) >> Engine Oil Pressure Check

Engine Oil Pressure Check

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to checking the engine oil pressure, a road test of 6 miles (10 kilometres), must be carried out. Do not attempt to attain engine normal operating temperature by allowing the engine to idle.
  1. Disconnect the battery ground cable. Refer to: SPECIFICATIONS
    WARNING:
    1. The spilling of hot engine oil is unavoidable during this procedure, care must be taken to prevent scalding.
    2. Wear protective gloves.
  2. Remove the engine oil filter element REFER to:

    OIL FILTER ELEMENT

    NOTE: Ensure the oil filter element is not contaminated during this procedure
  3. Install the oil filter element into special tool (Oil filter adapter number 303-1451)
  4. Install the special tool (Oil filter adapter number 303-1451) to the engine. Torque: 25 Nm
  5. Install the special tool (Oil pressure testing gauge, 303-871) and tighten the union
  6. Connect the battery ground cable
  7. Refer to owner hand book, check and top-up the engine oil if required
  8. Start and run the engine
  9. Note the oil pressure readings with the engine running at idle and 3500 RPM
  10. Turn off the engine
  11. Disconnect the battery ground cable
  12. Remove the special tools
    1. Clean the components
  13. Install the engine oil filter element REFER to:

    OIL FILTER ELEMENT

    NOTE: Ensure the oil filter element is not contaminated during this procedure
  14. Connect the battery ground cable
  15. Refer to owner hand book, check and top-up the engine oil if required