Brake Vacuum Pump - INGENIUM I4 2.0L Petrol (G2046495): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING

General Equipment: 2 post lift
Disconnect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Remove the oil pump chain.
Refer to: OIL PUMP CHAIN
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the oil pump solenoid electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the oil pump solenoid wiring harness from the 4 retaining clips.
CAUTION: Discard the vacuum pump seals.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 bolts securing the vacuum pump to the engine assembly.
- Remove the vacuum pump assembly and discard the vacuum pump seals.
CAUTION: Discard the oil pick up pipe seal.

NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 bolts securing the oil pick up pipe to the vacuum pump assembly.
Remove the oil pick up pipe from the vacuum pump assembly and discard the seal.