Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1817249): Removal
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Removal steps in this procedure may contain installation details.
- The brake vacuum pump is an integral component of the engine oil pump and cannot be serviced separately.
- Disconnect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: OIL PUMP CHAIN
Torque : 25Nm
-
NOTE: Do not disassemble further if the component is removed for access only.
Torque : 12Nm