Left Engine Mount (G2244077): Installation
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Install the left engine mount.
-
CAUTION: Make sure the engine mount is correctly installed in position.
Using the hydraulic jack, lower the engine.
General Equipment : Transmission jack
- Remove the hydraulic jack.
- Install the Air Conditioning (A/C) compressor and the 3 retaining bolts.
Torque : 25Nm
- Connect the A/C electrical connector.
-
CAUTION: Make sure that the accessory drive belt is correctly routed around all of the pulleys.
Using a suitable tool install the drive belt to the A/C pulley.
- Install the front wheel arch liner.
- Install the 2 engine mount bolts finger tight at this stage.
- Install the engine mount nut finger tight at this stage.
- Fully tighten the 2 engine mount bolts.
Torque : 60Nm
- Fully tighten the engine mount nut.
Torque : 60Nm
- Install the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD - PROJECT 8 .
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .