Drive Plate (G2246997): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the crankshaft and drive plate mating faces are clean before installation.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the drive plate in the correct position and tighten the 10 bolts to the correct torque.
  Torque
  
  Stage 1: 45Nm
  
  Stage 2: 90°
- Release the 2 bolts from the special tool and remove the special tool.
  Special Tool(s) : JLR-303-1304
Install the transmission assembly.
Refer to: TRANSMISSION - V8 S/C 5.0L PETROL, PROJECT 8 .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .